Hi ,
I want to migrate storage on VVR. Below are the steps I have in mind. Please correct me if I am wrong.
1. Stop the replication between DC1 & DR
2. Add the New array lun on primary site node.
3. Vxevac from Source lun to target lun. Same for SRL
4. Check the DCM for the Volume after the migration
5. Proceed the same on Secondary site and start replication
Below is the Diskgroup which I want to migrate.
rv rdu-rvg 1 ENABLED ACTIVE secondary 2 srl-vol
rl to_rdu-wc-ap-vvr rdu-rvg CONNECT ACTIVE rdu-wc-ap-vvr rdu-dg to_rdu-po-ap-vvr
v rdu-vol rdu-rvg ENABLED ACTIVE 100663296 SELECT - fsgen
pl rdu-vol-01 rdu-vol ENABLED ACTIVE 100663296 CONCAT - RW
sd t1disk02-01 rdu-vol-01 t1disk02 0 100663296 0 emc0_12cc ENA
pl rdu-vol-02 rdu-vol ENABLED ACTIVE LOGONLY CONCAT - RW
sd t1disk02-03 rdu-vol-02 t1disk02 100663808 512 LOG emc0_12cc ENA
pl rdu-vol-03 rdu-vol ENABLED ACTIVE LOGONLY CONCAT - RW
sd t1disk03-03 rdu-vol-03 t1disk03 205521408 512 LOG emc0_12cd ENA
pl rdu-vol-04 rdu-vol ENABLED ACTIVE 100663296 CONCAT - RW
sd t1disk001-01 rdu-vol-04 t1disk001 0 100663296 0 tagmastore-usp0_01eb ENA
v rdudb-vol rdu-rvg ENABLED ACTIVE 205520896 SELECT - fsgen
pl rdudb-vol-01 rdudb-vol ENABLED ACTIVE 205520896 CONCAT - RW
sd t1disk03-01 rdudb-vol-01 t1disk03 0 205520896 0 emc0_12cd ENA
pl rdudb-vol-02 rdudb-vol ENABLED ACTIVE LOGONLY CONCAT - RW
sd t1disk02-02 rdudb-vol-02 t1disk02 100663296 512 LOG emc0_12cc ENA
pl rdudb-vol-03 rdudb-vol ENABLED ACTIVE LOGONLY CONCAT - RW
sd t1disk03-02 rdudb-vol-03 t1disk03 205520896 512 LOG emc0_12cd ENA
pl rdudb-vol-04 rdudb-vol ENABLED ACTIVE 205520896 CONCAT - RW
sd t1disk002-01 rdudb-vol-04 t1disk002 0 205520896 0 tagmastore-usp0_01ec ENA
v srl-vol rdu-rvg ENABLED ACTIVE 314406576 SELECT - SRL
pl srl-vol-01 srl-vol ENABLED ACTIVE 314406576 CONCAT - RW
sd t1disk04-01 srl-vol-01 t1disk04 0 314406576 0 emc0_12ce ENA
pl srl-vol-02 srl-vol ENABLED ACTIVE 314406576 CONCAT - RW
sd t1disk003-01 srl-vol-02 t1disk003 0 314406576 0 tagmastore-usp0_01ed ENA
Thanks
Vel